Rubber Pole Base

This pole base makes installing your boat cover quick and easy. With the ability to swivel and hold the pole in place, you no longer have to climb in and out of your boat as you install your cover. The thermoplastic rubber gives the pad a firm grip, it's large base protects your flooring from damage caused by standard crutch tips and helps disperse the poles weight. Unlike our Pole Base w/support pole, this unique 4 piece design with locking wing nut ensures that this base will never end up at the bottom of lake. *Guaranteed to fit on Vico Marine's support poles only.

Bushing Option available in 7/8", 20.2 mm, & 1"
Easy tightening wing nut to help lock the pole in different angles
Works on seat cushions, EVA foam, or any other type of soft flooting
Best way to protect the bottom of your floor from crutch tip indents or marring from your support pole

Support Pole Tip Choices

Simple plastic ABS tip for protecting the top of your support pole for gouges or marring. Center has a thread hole to install snap tip if needed.

Best used in connection with Boat Vent products
Helps strengthen end of pole
ABS plastic.
Threaded center to add snap tip
Durable under hot or cold weather
Pressure fitted & crimped to permanently install into support pole

Snap Tip

ABS plastic tip used with snap covers. Snap is made from ridged stainless steel to avoid corrosion to bending under normal wear and tear.

Stainless Steel snap
Helps strengthen end of pole
ABS plastic.
Durable under hot or cold weather
Pressure fitted & crimped to permanently install into support pole

Swedge Tip

Standard Nylon swedge tip available for boat covers using grommets to tent. Works perfect for new covers or as replacement poles.

Made from tough Nylon material
Durable under hot & cold weather
Pressure fitted & crimped to permanently install into support pole

Our telescoping cam lock support poles are available in either have heavy duty polycarbonate or die cast aluminum collars. Both carry stainless steel components, allowing them to hold a staggering 120 - 160 lbs; that is over twice the weight of standard thumbscrew mooring poles. The aluminum tubing is light weight, anodized, and heat treated to make sure it can withstand any climate. Our poles come in a variety of sizes and tip options, including snap, swedge, plug, & spline.To protect your boats flooring from scuffs or marring, we use a synthetic TPE rubber crutch tip. Make sure to check out some of our Swivel Pole Bases for easier installation and use on upholstery.

Polycarbonate - Holds 120 lbs
Snap, swedge, plug, & spline
Silver Finished Anodized Aluminum
Ergonomic Cam-Lock for easy open and close
Sizes range from 70" extended to 28" (see chart)
2-Tip poles available with snap & swedge tip installed
Built to last - Strongest support poles on the market & will not collapse under load vs competition

Plug Tip